Adjusting the pressure setting of the press is an important and precise process. Here are some suggested steps to give clear guidance on how to make the adjustment:

1. Understand the bending model number and performance

First of all, you need to be familiar with the bending model you use and its performance parameters.

Consult the operation manual or technical specification sheet of the bending machine to understand the maximum pressure range of the machine, pressure adjustment mode and other key information.

2. Determine the pressure required

According to the thickness of the plate to be processed, hardness and the required bending Angle, the approximate required pressure range is calculated.

You can refer to the bending force calculation formula or consult the relevant table to determine the specific value of the required pressure.

3. Adjust the relief valve

Most bending machines are equipped with an overflow valve to adjust the system pressure.

Turn the handle of the relief valve clockwise or counterclockwise to gradually increase or decrease the system pressure.

When adjusting, you should proceed slowly and closely observe the reading of the pressure gauge to avoid excessive adjustment.

4. Observe and test

After adjusting the pressure, the actual bending test is performed.

Observe the quality of the workpiece after bending, and check whether there are tears, cracks or incomplete bending.

Based on the test results, fine-tune the pressure Settings until the best results are achieved.

5. Safety precautions

Before adjusting the pressure, ensure that the bending machine is powered off or in a safe state.

Wear appropriate personal protective equipment in case of accidents.

If you are not familiar with the operation, it is recommended to seek professional guidance or training.

6. Record and monitor

Record the pressure setting and corresponding bending effect after each adjustment.

Regular inspection and maintenance of the bending machine to ensure its stable performance, safety and reliability.

Through the above steps, the pressure setting of the bending machine can be effectively adjusted to obtain the best bending effect. Please note that different models of bending machines may have different adjustments and operating procedures, so it is always recommended to refer to the specific operating manual or contact the manufacturer for accurate guidance.

MAANSHAN KAIMI CNC MACHINE TOOL CO.,LTD is located in the beautiful city of Maanshan. The core products of the company are KMB type electro-hydraulic CNC bending machine, WC67Y, WC67K type ordinary CNC bending machine, QC11K gate shear, QC12Y, QC12K type hydraulic pendulum plate machine, and so on.